Stainless-steel-braided hydraulic hoses for water heaters undergo over-pressure testing at the final stage of manufacture. Before pressure is applied, a multi-sensor system checks each hose assembly to ensure that the correct mechanical parts have been fitted. Applying high pressure to an incomplete assembly could result in catastrophic failure, damaging test equipment and putting operators at risk of injury.


Vantaggi per il cliente

  • Reliable, repeatable detection of three discrete parts in a single operation
  • Elimination of unsafe occurrences due to faulty hose assemblies
  • Highly cost-effective solution to a previously insoluble problem

Vantaggi specifici del prodotto

  • Exceptional sensing distances in small sensor envelopes
  • Correction factor of 1.0 for brass allows extended sensing distance
  • Sensors operate in close proximity without interference

Applicazione del cliente

A Portuguese manufacturer of stainless-steel-braided high-pressure hoses for water heaters carries out mandatory over-pressure testing on every hose assembly. If either of the mechanical unions fitted to the ends of each hose is incorrectly assembled, it will leak under pressure.   Occasionally, a component is omitted entirely, making a hose liable to fail catastrophically under high pressure. To avoid damaging test equipment and endangering personnel, a sensor system must confirm the presence of three critical parts on each union before testing commences.   Each extra test extends the process cycle time. The customer requires a single test fixture capable of carrying out three presence checks concurrently, minimizing the additional cost.   The three critical parts, made from stainless steel, carbon steel and brass, respectively, are positioned in close proximity when assembled. Access is limited; the three sensors must be small, yet sense these materials reliably at distances up to 6mm (0.25in).

Soluzione del cliente

By mounting three separate M8- and C5-sized Contrinex inductive sensors in a single fixture, all the demands of this application can be met in full. Each sensor is chosen for its combination of size, sensing distance and reliable detection of one of the three different materials   To detect the brass union nut, an M8-diameter sensor from the Basic range (Extra Distance family) with a 4mm sensing distance is an excellent choice. Fully embeddable with chrome-plated nickel-silver bodies and PBTP sensing faces, this sensor has a correction factor of 1.0 for brass, outperforming competitors.   For detecting the steel spring, a 5mm-square-section sensor from the Miniature range (Classics family) is an ideal option. Embedding the sensor makes optimal use of its 1.5mm sensing distance, and its chrome-plated brass body is well-suited to the environment.   Finally, to ensure reliable detection of the stainless-steel collar, an M8-diameter sensor from the Extreme range (Full Inox family) was chosen. Its one-piece AISI 303 (V2A) stainless-steel construction is combined with an extended operating distance of 6mm.   Each sensor is configured with an industry-standard PNP normally-open interface and features a hermetically sealed cable entry. All three are connected to the customer’s control equipment via PUR-sheathed cables. Delivering the required detection capabilities and sensing distances in small-bodied sensors enables Contrinex to solve a previously insoluble problem.